UniPi
Supports UniPi 1.1, UniPi Lite and all Neuron models as well as the Neuron extensions.
This plug-in does not make use of Evok, it communicates directly with the Modbus TCP layer, or over Modbus RTU with the Neuron extensions. To add one-wire devices, use the nymea onewire plug-in.
Supported Things
- UniPi 1.1
- UniPi 1.1 light
- Neuron
- all models
- Neuron Extensions
- all models
General Features:
- No internet connection required
- Switch digital outputs
- Read digital inputs
- Switch user led
- Set analog outputs
- Read analog inputs
Requirements
- UniPi 1.1 & UniPi 1.1 light
- Neuron
- Neuron TCP modbus server must be installed.
- Neuron Extensions
- Set the DIP settings accordind to the plug-in settings
- General requirements:
- The package “nymea-plugin-unipi2” must be installed
- For one-wire sensors the package “nymea-plugin-onewire” must be installed.
Device setup for Neuron devices
The nymea unipi plug-in requires the Neuron UniPi Kernel for Neuron devices, this is not required for Neuron Extensions or UniPi 1.1. To install the kernel module follow the instuctions in the UniPi knowledge base.
https://kb.unipi.technology/en:sw:04-unipi-firmware
Before you can add IOs you need to setup the UniPi Gateway device inside nymea, after that nymea recognises the available IOs.